#3472 Object dimensions not respected

In general, if the ribs are not good, it is due to the shrinkage of the material in many cases.

You can initially increase the material flow to compensate for this, or at least part of it. Increase the extrusion multiplier in 2% increments to compensate for shrinkage as closely as possible, without the flat surfaces becoming rough (too much flow in this case).

You have not found an answer to your problem:

Login to your account

Ce site Web utilise des cookies pour améliorer votre expérience. Nous supposerons que cela vous convient, mais vous pouvez vous désinscrire si vous le souhaitez.