Q&A

PRINTERS

FAULTS / CASSES

It is possible that the bed cable of “Stream 30ULTRA” has a problem during its installation. It is also possible that the cable will wear out over time. We advise [...]
Indeed, this happens, and can cause a lot of damage when the machine keeps printing in a vacuum. In particular the destruction of the extruder because the material extruded in [...]
Can you try to reset the factory settings by going to MENU->Configuration. Then click on “Factory settings”, then “Save” and restart the machine.Then try the Home Z to see if [...]
If the Z-axis is only going up and not down, it is likely that your Z-limit sensor has failed or is malfunctioning.Check that the little red button on top of [...]

Login to your account

Cookies
Ce site Web utilise des cookies pour améliorer votre expérience. Nous supposerons que cela vous convient, mais vous pouvez vous désinscrire si vous le souhaitez.