In case of emergency, you can deactivate it via the MENU->CFG. SYSTEME->Detect. end of thread to be set to OFF, then save.The photo below will allow you to adjust its [...]

DUAL 3D printers have two filament sensors. One is in head 1 and the other in head 2. However, the detectors do not work independently but by an all or [...]

Case n°1 : A bad use of the machine, the Z endstop “blocked” thus remains engaged.Check that the microswitch (the little red button) is not blocked. To do this, you [...]

Regarding maintenance, the ULTRA SC are equipped with predictive maintenance. The machine itself will suggest at the right moment the intervention(s) to be performed based on the time of use. [...]